Jump to content
  • 0

can't connect to CNCNET all of a sudden


jukvox
 Share

Question

I've been playing RA since 1996 and the last time I connected to CNCNET was about 1 week ago... been using it for years. Now I can't connect all of a sudden.

WHAT HAPPENS:
The little update-box that appears before CNCNET opens, does not finish the update, what I mean is, that little box goes away and the "checking for updates" and Total Progress" section don't even begin to fill up with the little boxes that let you know the progress of the update... so it just closes and then CNCNET opens up; but stays on a endless loop of "attempting to reconnect."

Any ideas?

Screen Shot 2020-04-04 at 9.44.50 PM.png

Link to comment
Share on other sites

1 answer to this question

Recommended Posts

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...