Jump to content
  • 0

Issues running on Ubuntu


otter_computer

Question

Been trying to capture some nostalgia by playing some RA2 but having trouble getting the CNCNet client to launch on linux. I can get it to open after initial install, at which point it does an update, but then refuses to start again after restarting. Anyone have any recommendations on what to try or what debugging steps I can take?

This is on Ubuntu 21.10 running various versions of Proton and Wine.

Link to comment
Share on other sites

1 answer to this question

Recommended Posts

  • 0

I am having the same problem on Ubuntu 22.04. I have installed the client from the repository on other machines with various linux distros in the past, each time it is slow to install (it would hang, but after a reboot would resume and finally install fully). This time I am having no luck.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...